TRENDnet TI-RG262i - Jumbo Frame

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
30
Web Configuration
Basic Settings > General Settings > System
IP Address
Configures a IPv4 address for your Switch in dotted decimal
notation. For example, 192.168.10.200.
Subnet Mask
Enter the IP subnet mask of your Switch in dotted decimal
notation for example 255.255.255.0.
Default Gateway
Enter the IP address of the default outgoing gateway in dotted
decimal notation, for example 192.168.10.1.
Jumbo Frame
Jumbo frames are Ethernet frames with a payload greater than 1500 bytes. Jumbo frames
can enhance data transmission efficiency in a network. The bigger the frame size, the
better the performance.
Notice:
The jumbo frame settings will apply to all ports.
If the size of a packet exceeds the jumbo frame size, the packet will be dropped.
The available values are 10240, 9216, 1552, 1536, 1522.
Default Settings
The default jumbo frame is 10240 bytes.
CLI Configuration
Node
Command
Description
enable
show jumboframe
This command displays the
current jumbo frame settings.
configure
jumboframe
(10240|9216|1552|1536|1522)
This command configures the
maximum number of bytes of
frame size.
Web Configuration
Basic Settings > General Settings > Jumbo Frame
Parameter
Description
Frame Size
This field configures the maximum number of bytes of frame size
for specified port(s).
Apply
Click this button to take effect the settings.
Refresh
Click this button to reset the fields to the last setting.