TRENDnet TPE-5240WS - Page 8

© Copyright 2023 TRENDnet. All Rights Reserved.
ii
TRENDnet User’s Guide
PoE Web Smart Switch Series
Diagnostic LEDs
• Power LED
On
:
When the Power LED is on, the device is receiving
power.
Off
:
When the Power LED is off, the power adapter is
not connected or the device is not receiving power.
• PoE MAX (Power over Ethernet Max.)
On
:
When reaching near the max PoE power budget
provided 75W or above, the LED will turn on and
the system will not provide power additional PD
(PoE client devices) after max PoE budget is
reached.
Off
:
When the PoE power provided is below the 75W
PoE power budget.
• Gigabit Ethernet PoE+ Port LEDs (1-8)
Link/Activity button Mode
Green
on
:
When the Green LED is on, the respective port is
connected to a 1Gbps Ethernet network.
Amber
on
:
When the Green LED lights on, the respective port
is connected to a 10/100Mbps Ethernet network.
Green
Blinking
:
When the LED is blinking green, the port is
transmitting or receiving data on the network at
1Gbps speed.
Amber
Blinking
:
When the LED is blinking amber, the port is
transmitting or receiving data on the network at
10/100Mbps speed.
Off
When the LED is off, the respective port is
disconnected.
• Gigabit Ethernet Port PoE+ LEDs (1-8)
PoE LED button Mode
Green
on
:
When the Green LED is on, the connected device is
receiving power.
Amber
on
:
When the Amber LED lights on, the connected PoE
device is not receiving power. The cause is either
insufficient power budget, or due to
Class/PowerLimit restrictions in the PoE
configurations.
Off
:
When the LED is off, the respective port is either not
connected to a PoE device or is disconnected.
• SFP Slots (9-10)
Link/Activity
Green on
:
When the SFP LED is on, the link established
using the SFP module is operating at 1Gbps
speed.
Green
blinking
:
When the SFP LED is blinking, the port is
transmitting or receiving data on through the
1Gbps link established.