The 8-Port 10/100Mbps PoE Switch, model TPE-S80, reduces equipment
and installation costs by delivering data and power over existing Ethernet
cables to Power over Ethernet (PoE) enabled devices such as Access
Points and IP Cameras.
Boost office efficiency and reduce network congestion with a total
switching capacity of 1.6Gbps. LED indicators display device status for
easy power management and troubleshooting. An internal power supply
reduces clutter and delivers 15.4 Watts to each PoE port. A convenient
on/off button is located on the back of the switch. Non-PoE devices can
connect to the switch—auto-sensing PoE technology cuts power to non-
PoE connected devices. Use TRENDnet's PoE Splitter with the TPE-S80
to install non-PoE devices in remote locations.
TPE-S80 (V1.0R)
8-Port 10/100Mbps PoE Switch
TPE-S80
rev: 04.27.2010
Features
• IEEE 802.3af Power over Ethernet (PoE) compliant
• 8 x 10/100Mbps Auto-MDIX RJ-45 PoE ports
• On/Off power switch
• Provides 15.4 watts per PoE port
• Supports PoE Powered Device (PD) classification
• 1.6Gbps switching fabric
• Full wire-speed non-blocking reception and transmission
• Store-and-forward switching method
• Back pressure Flow Control for half-duplex mode
• IEEE 802.3x Flow Control for full-duplex mode
• 512Kbits RAM Data Buffer and 1K MAC address entries
• Diagnostic LEDs (Power, Link/Activity, PoE Act/Status)
• Plug and Play
• Sturdy metal enclosure
• Mounting hardware included
• 5-year limited warranty
network
accessories
To Next Page
Need help?
General
