Need help?Do you have a question about the TRENDnet TPE-S80 and is the answer not in the manual?
Details essential hardware and environmental conditions needed for setup.
Guides on connecting the power cord and turning the switch on.
Instructions for connecting computers and PoE devices via RJ-45 cables.
Checks key panel lights (Power, PoE, Link/ACT) after setup.
Instructions for securing the mounting brackets to the switch chassis.
Steps to carefully position and secure the switch in a standard rack.
Steps to diagnose and fix issues where LEDs do not turn on.
Solutions for when a PoE-powered device fails to receive power.
General| Ports | 8 x 10/100/1000Mbps |
|---|---|
| Switching Capacity | 16 Gbps |
| Forwarding Rate | 11.9 Mpps |
| RAM Buffer | 512 KB |
| Switch Type | Unmanaged |
| Power Input | 100-240VAC, 50/60Hz |
| Mounting Options | Desktop |
| Power Supply | External |
| Standards | IEEE 802.3, 802.3u, 802.3ab |
| MAC Address Table | 8K |
| Operating Temperature | 0 °C to 40 °C (32 °F to 104 °F) |
| Humidity | 10 – 90% (non-condensing) |
To Next Page
