• It is prohibited to carry out any modifications to
the appliance without prior written consent from
Triangle Tube.
• Faulty parts must only be replaced by genuine
Triangle Tube factory parts.
• Failure to comply with these instructions can result
in minor property damage, or injury.
CAUTION
• The homeowner is only permitted to carry out the basic
set-up operations (EZ Setup) after he has received all
relevant instructions from the installer. Any other set-
up must be carried out by a qualified installer.
• In case of any anomaly, please call your qualified
service technician.
• Make sure to reference the unit’s model number and
serial number from the rating label when inquiring
about service or troubleshooting.
• Triangle Tube reserves the right to change the
technical characteristics, components and features of
its products without prior notice. Check for an updated
version of this manual at www.triangletube.com.
NOTICE
• A byproduct of any gas fired appliance is carbon
monoxide. Triangle Tube requires the installation
of a minimum of two (2) hard-wired carbon
monoxide detectors with an alarm and battery
back-up; one in the mechanical room where
the boiler is located and another installed in
the living area outside the bedroom(s) for all
installations. Consult the local authority having
jurisdiction for any additional carbon monoxide
detector requirements in your area. See Chapter
2 of the Prestige Installation & Maintenance
Manual
for additional carbon monoxide detector
requirements in Massachusetts.
• Failure to comply with these instructions can
result in substantial property damage, serious
injury, or death.
Service and Maintenance:
• Allow the unit to cool down prior to servicing to
avoid severe burns.
• The PRESTIGE must be maintained as outlined
in this manual and have at least annual service
performed by a qualified service technician to
ensure unit / system reliability.
PRESTIGE Operation
• Do not block flow of combustion air to the
PRESTIGE. If the combustion air blockage is easily
accessible and removable, then remove it. If
blockage is not obvious or cannot be removed,
have the unit and system checked by a qualified
service technician.
• Do not allow contaminated air to enter the unit’s
combustion air inlet. See page 3 for details.
• The PRESTIGE is equipped with a low water cutoff
device. The boiler and system piping must be
filled and pressurized to 12 psig prior to startup.
The unit will shut down if the pressure falls below
7.2 psig.
• Should overheating occur or if the gas supply
fails to shut off, DO NOT turn OFF or disconnect
the electrical supply to the pump. Instead, turn
OFF the manual gas control valve external to the
appliance.
WARNING
Boiler and System Water
• Have the boiler and system water chemistry
checked at least annually by a qualified service
technician.
• Do not use petroleum-based cleaning or sealing
compounds in the boiler or system. Gaskets and
seals in the system may be damaged, which can
result in substantial property damage.
• Do not use any product not specifically designed
for boiler / hydronic heating systems. Serious
damage to the unit, piping system, personnel
and / or property may result.
• Continual fresh makeup water will reduce the life
of the PRESTIGE. Addition of oxygen can cause
internal corrosion in the system components. All
leaks in the system must be repaired at once to
prevent excessive makeup water.
• Do not add cold makeup water when the
appliance is hot. Thermal shock can potentially
cause cracks in the heat exchanger.
• Failure to comply with these instructions can
result in substantial property damage, serious
injury, or death.
vi
SAFETY
PRODUCT AND SAFETY INFORMATION
To Next Page
Loading...
Need help?
General
