Installation
In the main menu, select the line Installation using
and confirm with OK. The Installation menu
will appear:
Use the buttons to make your selection and
confirm with OK.
Installation – channel search
You can choose between automatic (antenna) and manual (transponder) channel search.
The automatic channel search checks the whole VHF and UHF range for programmes you
can receive.
Automatic channel search
In the Installation menu, move the cursor using the buttons onto the line Channel search
and press the OK button. The following menu will appear:
Performing an automatic channel search
Select the line Antenna using and Terrestrial using the ◄ or ► buttons.
Select the line Search mode using and Antenna using the ◄ or ► buttons.
In the line Encrypted, select whether the channel search should also include encrypted
channels, using the ◄ or ► buttons.
No = encrypted channels will be ignored.
Yes = encrypted channels will be included in the search.
Move the cursor onto the line Start scan using the buttons and start the search process
by pressing the OK button.
Now two windows are shown, listing the newly found TV and radio programmes. The “Status”
window shows how far the search has progressed.
- Display: Scanning => Search is active
- Display: Complete => Search is finished.
You can leave this menu by pressing EXIT. If not finished, the channel search algorithm is
aborted. If new channels are found, you are asked to store them (Yes). Select your choice by
◄/► and confirm with OK. If selected YES the new channels are stored at the end of the
channel list now.
To Next Page
Loading...
