Installation – Software download
With this function the operating software of the receiver, it´s menu texts and channel list can
be updated. Precondition is a Download-channel allocated by your cablenetwork provider.
You can gather informations from you cablenetwork provider.
Your currently active channel list is not changed by a software update.
Attention:
- In case of a software update the current operating software will be erased and a new
software version will be installed.
- When updating the channel list the factory default channel list will be replaced by a new
one.
- When updating the OSD texts, all menu texts are erased and actualised.
The update process is subdivided into following steps:
1. Select the channel with the download informtion.
2. Open Update Menu:
Enter the Installation menu, select line Software download and confirm with OK.
The Download menu for controlling the update process is opened and the search for the
download channel starts automatically.
Please wait until this search is completed. It may take a few minutes. When the download
stream is found the receiver verifies whether there are available new versions of the operating
software, OSD texts and channel list. The result is shown in the Download menu behind the
corresponding menu items (marked by ).
If there are no new data available this is signalled by a „-“.
You can leave the download menu by EXIT.
3. Selection of available data:
Depending on their availability in the update stream you can select the download of following
data by pressing :
a.) Software: Operating software
b.) Channel list: Channel list
c.) OSD texts: All menu texts displayed on the screen
d.) Information: Information concerning the available download data e. g.
version number, innovations, etc..
To Next Page
Loading...
