Timer
You can use the record timer functionality to programme a recording for a connected video
recorder. Totally 10 record timers can be activated.
Or you can use the sleep timer to specify a time at which the
receiver is to switch into standby mode.
Therefore please enter the Main menu by pressing Menu; then
select menu item Timer and confirm with OK.
Timer – record timer
Use to select line Record timer in menu Timer and press OK.
The following menu appears:
Programming a record timer:
1. Select line Timer index (1...30) with
2. There select timer place with ◄ ►
3. Select lines Start at , Stop time or date of recording with using and confirm with OK
4. Enter the required time or date by pressing 0-9
5. Confirm your input with using OK
6. Select line Station with and confirm with OK
Select a channel with or ◄ ► and confirm with OK.
7. Select line Repetitions with and use ◄ ► to specify the number of repetitions of this
record.
8. Select line Activate timer and activate the programmed record timer by pressing OK
there (text Activate timer changes to Deactivate timer).
The receiver will switch on at the programmed time and signals a timer record by displaying
“rEC.“ in the 4 digit LED Display. If you want to abort a record, please enter the record timer
menu and deactivate the timer by pressing the Deactivate button.
If you push one of the buttons or ◄►, following menu appears:
Choose „Yes“ to stop the record or „No“ to continue the record.
Hint: Please make sure that the local time of the receiver is set correctly and the video
recorder is programmed, too.
To Next Page
Loading...
