What to do if my Tribest Juicer stops during operation?
If your Tribest Juicer stops during operation, you can try the following: * Use the REV button to dislodge any stuck pulp or produce. * Feed the juicer at a slower pace. * Cut your produce into smaller pieces.
How to fix a Tribest Juicer that won't turn on?
If your Tribest Juicer motor does not turn on, ensure the power cord is plugged into a working socket and that all parts have been assembled correctly.
Why is my Tribest Juicer leaking from the bottom of the Auger Housing?
If your Tribest Juicer is leaking from the bottom of the Auger Housing, it could be due to the following reasons: * The silicone sealing ring may not be in place at the bottom center of the Auger Housing, so check if it is properly positioned. * There may be damage to the silicone sealing ring, so inspect it for any signs of wear or breakage. Also, try feeding the juicer at a slower pace.
What to do if I have trouble removing the Feeding Chute from my Tribest Juicer?
If you're having trouble removing the Feeding Chute from your Tribest Juicer: * Check whether there is a lot of pulp in the Auger Housing. If so, turn the juicer on to remove the excess pulp. * Check whether there are any hard objects stuck in the Feeding Chute. The REV button may help dislodge them.
Why does the Auger Housing move while juicing with my Tribest Juicer?
The movement of the Auger Housing while juicing with your Tribest Juicer is normal during operation and is designed to reduce strain on the moving parts.
Provides essential safety precautions for operating the juicer, including usage restrictions and warnings about potential hazards.
Align the mark on the Auger Housing with the mark on the Main Body and rotate clockwise.
Insert the Juicing Screen into the center of the Auger Housing until it is firmly seated.
Insert the Auger into the center of the Juicing Screen and through the silicone sealing ring.
Align the mark on the Feeding Chute with the mark on the Auger Housing and rotate clockwise.
Place juice and pulp containers and insert the pusher into the feeding chute.
Details the operation of the ON, OFF, and REV functions of the juicer's power switch.
Rotate the Feeding Chute counterclockwise to unlock and pull upwards.
Pull the Auger straight up and out of the Juicing Screen and Auger Housing.
Pull the Juicing Screen straight up and out of the Auger Housing.
Rotate the Auger Housing counterclockwise to unlock and pull upwards.
Checks for power connection and correct assembly. Recommends contacting customer service if issues persist.
Addresses pulp blockage in the Auger Housing or Feeding Chute, suggesting REV button use.
Provides solutions for jamming, including using the REV button and feeding at a slower pace.
Investigates leaks, checking the silicone sealing ring's position and condition.
Explains that Auger Housing movement during juicing is normal and reduces strain.
To Next Page
General
