Tribest slowstar SW-2000

Questions and Answers

W
Willie GouldAug 15, 2025
Why does my Tribest slowstar SW-2000 motor stop during use?
- J
  Jesse SteeleAug 15, 2025
  If the Tribest Juicer motor stops during use, it might be due to inserting too many ingredients at once. To resolve this, turn the switch to ‘OFF’, then to ‘REVERSE’ to unclog the materials, and finally to ‘ON’ to push the materials down. Repeat this process up to three times. Also, the motor may overheat. Turn the switch to “OFF” and let the juicer rest in a cool area for an hour to cool down the motor before trying again. Ensure you remove hard seeds from ingredients before juicing, as they can damage the juicing screen and Duoblade Auger.
M
Mr. Jacob RogersAug 17, 2025
Why is my Tribest Juicer making so much noise?
- Y
  Yesenia GonzalezAug 18, 2025
  If you hear unusual sounds coming from your Tribest Juicer, first turn it off and check if all parts are correctly assembled. Also, ensure the juicer is placed on an even surface. Some squeaky friction noise is normal during operation and shouldn't be a cause for concern. Finally, check that the juicing materials are cut to the right sizes.
V
vharrisAug 21, 2025
What to do if my Tribest slowstar SW-2000 is not extracting enough juice?
- J
  Jacob AlvarezAug 21, 2025
  If your Tribest Juicer isn't producing enough juice, remember that the amount of juice varies depending on the freshness of the food. For better results, refrigerate the ingredients and soak them in clean water for about 10 minutes before juicing. Also, verify that the Pressure Plug is correctly assembled.
D
Daniel AcostaAug 25, 2025
How to fix a Tribest Juicer that does not turn on?
- J
  Joanne PruittAug 25, 2025
  If your Tribest Juicer isn't working, make sure the power cord is properly plugged in. Also, check that all the components are correctly assembled.
J
Joan KellyAug 28, 2025
What to do if my Tribest Juicer is leaking juice?
- M
  mejiajohnAug 28, 2025
  If juice is spilling out of your Tribest Juicer, check if the pressure plug is assembled properly.
R
Robert GravesAug 31, 2025
Why are the parts of my Tribest slowstar SW-2000 discolored after juicing?
- K
  Katherine HallAug 31, 2025
  If the color of the juicing parts and juice container of your Tribest Juicer changes after extraction, it may be due to not cleaning the juicer immediately after use, making it harder to clean and potentially reducing its performance. Also, disassemble the silicone blades and wash them separately.
C
Cheryl SmithSep 4, 2025
Why is the Duoblade Auger in my Tribest Juicer grinding?
- V
  Vincent SandersSep 4, 2025
  The Duoblade Auger in your Tribest Juicer may grind if you operate it without feeding any food.
S
Susan BrennanSep 6, 2025
Why is the juice container shaking on my Tribest Juicer?
- G
  gonzalezjamesSep 7, 2025
  It is completely normal for the juice container of your Tribest Juicer to shake a little during operation.
P
Patricia PetersonSep 10, 2025
How to disassemble the feeding chute on a Tribest slowstar SW-2000?
- D
  dwaynefrazierSep 10, 2025
  If the Feeding Chute Assembly of your Tribest Juicer is difficult to disassemble, firmly grab the Feeding Chute and rotate it counter-clockwise with force.