3
1 Vorwort
1 Introduction
Valued Trigon - Customer,
We are excited that you have chosen to purchase the Energy integrated amplifier.
This unit was built using the highest quality control to insure utmost precision in
manufacturing.
Whether you are a beginner to High-Fi or advanced user, it is highly recommended that
you read and understand this Users Manual thoroughly before using your new integrated
amplifier.
Be sure to keep this manual easily accessible as it could come in handy during normal
use of this amplifier.
We hope that you enjoy your new amplifier and thank you for choosing Trigon.
2 General Description
The Energy is a High-End integrated amplifier with seven high-level inputs.
This amplifier is completely controlled by a sophisticated Microprocessor. The features of
the Energy are both accessible via the front panel or via the Director remote control.
The front panel features a dimming Display that informs users of the active in-use
configuration. The unit can also be turned off or on via the remote control when in stand-
by mode.
The volume setting is controlled through a special D/A Converter and as such is both
technically and sonically far superior to a traditional volume pot (potentiometer). This
method of volume control allows for a channel output that is exact at low volume as well
as high volume settings, insuring that the soundstage doesnt wander or lose focus with
each change of the volume setting.
The power supply also boasts noteworthy features in its design. Every stereo channel has
it own torrodial transformer. This so-called double mono structure ensures optimal
channel separation where more power being sent to one channel has no impact on the
other channel. The controlling microprocessor is powered by a small standby power
supply. Therefore, the sensitive audio signals remain separated, i.e. they will not be
adversely affected by the digital section of the integrated amplifier.
The Energy is equipped with seven high-level inputs including one balanced input as
well as an effects loop (Splitt) where a surround processor or other effects unit (such as
an equaliser) can be connected.
In addition, the integrated amplifier features a preamplifier output which can also be used
as a tape record output, if required.
Two loudspeakers (4 to 8 Ohm) can be connected to the massive gold-plated binding
posts of the terminal provided at the rear panel. A 6.3mm stereo headphone plug
(impedance 32 to 2000 Ohm) can be inserted into the jack provided at the front panel
featuring its own special headphones amplifier.
To Next Page
Loading...
