Trigon Energy - 2.1 Safety Information; 2.2 Installation Information

4
2.1 Safety Information
Trigon Elektronik GmbH will not assume any responsibility for damages
occurred from unsafe handling of the product or from not adhering to the recommend
safety instructions below.
- The amplifier should not be used un-monitored in close proximity to heat producing
devices such as Water heaters, Fireplaces or Flammable materials.
- The amplifier is not designed to withstand heavy impacts or severe vibrations.
- The amplifier should not be used un-monitored when being transported from a cold
environment into a warm room.
- The amplifier should not be used when placed out in direct contact with the Sun.
- Insure that the installation location for this product has adequate ventilation.
- The amplifier should not be doused with any type of liquid. It is imperative that no
liquid get inside the unit.
- Never use this product without the shielded top cover installed.
- Before removing the top cover always insure that the AC cord has been removed
from the AC outlet and that the product has sat to drain any residual current.
- Never short any of the fuses. Replace broken fuses only with original fuses of the
same value and type.
- Do not attempt to service this unit. Repairs are only to be done by authorized
service centers or through the factory direct. Any such unauthorized repairs will
result in a voided warranty.
- Always make sure that your complete audio system is shut off before changing any
cables or connecting any other components.
The Energy power supply is set at the factory to be operated in 115V. Contact your
local dealer or Trigon directly if you should need a different voltage version.
2.2 Installation Information
During unpacking, please inspect the unit for any potential transportation damage. If you
notice any damage, please get in contact with your dealer.
Confirm the contents of the box. In addition to the Energy, you should also have the
following:
- User󰾺s Manual
- Warranty Card
- Power cord
Place the unit on a dry, level surface. Be sure that the unit has good ventilation around it.
Strong magnetic fields commonly found in amplifier transformers and halogen light
transformers can induce hum into a system. Because of this, it is best to place the unit a
reasonable distance from such devices. Also, the audio interconnects should not be run