5
in parallel to AC power cables as this can also induce noise.
Hum is also produced from light bulbs. It is best to place audio equipment at least 3 feet
away from them.
Try to utilize natural light and make sure not to use the Energy unmonitored next to
heat sources.
2.3 Warranty and Service Information
In choosing the Energy, you have selected a valuable and technologically advance
product. We at Trigon are trying to improve our quality control through all steps in
the production cycle to insure that all Trigon products meet our quality expectations.
If a problem is experienced, Trigon Elektronik GmbH offers a three-year
warranty. This warranty covers repairs for any manufacturing defects.
It does not cover damages that are the result of neglect or misuse. It also is considered
void if unauthorized personnel do any repairs or modifications. Any alterations to the
serial number, or transportation damage are not covered as part of this warranty.
3 Initial Setup
After you have unpacked the preamplifier, you should first connect the unit to the power
supply and plug it into the AC outlet. Before you have connected any of your other
components turn the unit on to test that it powers up properly.
After a short warm-up period, you will hear a quiet clicking sound from Relays within the
Energy signalling that the unit is ready to be operated. At this time you should
become more familiar with the proper usage and connection possibilities of the
Energy. Test the various controls (i.e. input selection, volume, etc..) at this time for
functionality, while none of your sources are connected. This will insure that no damage
can occur. After you have tested all the functions and understand how to control the
Energy, you can begin to connect your other audio components.
When connecting cables between components, be sure that both the Energy and
other components are powered OFF!
3.1 Front Panel Controls
To Next Page
