TriMark e-ASK UM28 - Assign New Access Codes

Assign New Access Codes
The Access Codes are used to unlock or unlatch the door. The Access
Codes must be EXACTLY 5 digits long. With a valid Authority Code, an
Access Code can be programmed with the following instructions:
1. Press the (5 / 6) button for 5 seconds until the keypad beeps.
The backlighting of the keypad will flash (if equipped) indicating
the keypad is in “Learn Mode.”
2. Enter the 5-digit Authority Code (see page 5 for the code).
 If you enter an INCORRECT Authority Code, the keypad will
beep for 1 second, and leave “Learn Mode.”
 If you enter a CORRECT Authority Code, the keypad will
provide a very short beep, indicating that you must define a
memory bank to store the new Access Code.
3. Press and release the button that corresponds to the memory
bank. For example, press (1 / 2) button for Memory #1 and
press (3 / 4) button for Memory #2. During this step, you are
choosing 1 of 5 memory banks.
4. Enter a new 5-digit Access Code. The keypad chirps 3 times
after the 5
th
digit’s entry.
5. Re-enter the new Access Code for confirmation. The keypad will
chirp 3 times after a successful confirmation. A long beep
indicates a failure to change the code.
6. Test the new code to confirm a successful change.
Repeat process to assign additional Access Codes.
Notes:
 Up to 5 different Access Codes can be assigned at any time. As
additional Access Codes are defined, pre-existing Access Codes
are overwritten. For example, if a new Access Code is assigned
to Memory #3, the previous Access Code in Memory #3 is no
longer valid.
 If an error is made at any point, or if time runs out, the keypad will
exit “Learn Mode,” provide a 1-2 second beep, and not change
anything.
The following area can be used to document the new Access Code assignments:
Memory # User Name Digit 1 Digit 2 Digit 3 Digit 4 Digit 5
1/2
3/4
5/6
7/8
9/0
6