Deactivate Lock Confirmation
The system defaults to confirmation ON with power-up. Horn and
headlight confirmation can be toggled off and on from the keypad.
1. Press and hold the (5 / 6) or (3) button for 5 seconds until the
keypad beeps.
2. Enter the Authority Code. The buzzer stays on.
3. Hold the (1 / 2) or (1) button for 5 seconds. A double-beep
sounds.
4. The ON/OFF status of confirmation output (lights and horn) is
toggled.
Alarm
After locking all doors, the system is armed. In cargo mode, both the
entry door and compartment doors must be locked within 10 seconds to
set the alarm. The alarm is activated when any entry door or
compartment door is opened if it is being monitored by an installed
security swtich, or by an input from a security sensor (shock sensor,
motion sensor or other sensing device).
When alarm is triggered, the siren is continuously activated and
headlights flash for 1 minute.
To deactivate alarm mode:
Unlock all doors via e-FOB transmitter.
Unlock system via e-PAD or vehicle switch.
Start the engine (only works if engine monitoring is installed).
The following table describes audio/visual activations at various
conditions.
8
Outputs
Lock
Confirmation
Unlock
Confirmation
Alarm
Siren
Not used Not used 1 minute or when shut off
Horn
1 chirp 2 chirps Not used
Headlights
1 flash 2 flashes 1 minute or when shut off
To Next Page
Loading...
