TRIMOS V1000+ User Manual

TRIMOS SA Av. de Longemalle 5 CH 1020 Renens Switzerland
Tel ++ 41 21 633 01 01 Fax ++41 21 633 01 02 office@trimos.ch http://www.trimos.ch
Page 1
User’s manual
V300+ / V600+ / V1000+
Version N°2.0 – E

TRIMOS V1000+ Specifications

General

Measuring Range	0 - 1000 mm
Resolution	0.1 µm
Repeatability	0.2 μm
Display	LCD
Interface	RS232

Summary

Description of the instrument

Specifications

Unpacking and installation

Getting started

Key operational adjustments

Adjusting the measuring pressure

Procedure to adjust the force applied by the measuring probe for optimal accuracy.

Adjusting probe suspension

Procedure to fine-tune the probe's floating suspension for consistent measurements.

How to start up

Setting the probe constant

Procedure to set the probe constant for measuring reversed surfaces or diameters.

Measuring heights

Steps for taking reference and measuring heights with the instrument.

Measuring diameters and centerlines

Steps for measuring diameters and centerlines using the instrument's modes.

Measuring with min and max mode

Procedure for using the min/max mode to capture extreme measurement values.

Measuring with Delta mode

Guide to using the Delta mode for measuring differences between two points.

Measuring of squareness

Method for measuring the squareness of a surface using the instrument.

Measuring with two references

Instructions for setting and using two reference points (REF I and REF II).

Maintenance and support

Instrument maintenance

Guidelines for caring for the measuring instrument to ensure longevity.

Complaints and repairs

Procedure for handling instrument breakdowns and warranty claims.