TRIOBIKE BOXTER - Rear Drive E-System; Turning On the System; Using the System

36
REAR DRIVE ESYSTEM
TURNING ON THE SYSTEM USING THE SYSTEM
Triobike mono rear drive features a pedal-assist electric drive system manufactured by
Promovec: PLEASE CAREFULLY READ ITS MANUAL.
- Rotate the key on the battery case to the right: the rear light should switch on when the
system is active.
- Press ON/OFF button on the handlebar control. To turn off the system, press the power
button on the handlebar control. When the display is off, the complete system is off too.
IMPORTANT: don’t leave the battery charging too much time after
the full charge. When the battery is fully charged disconnect it from
the charger.
YES
NO
DECREASE
SUPPORT
LEVEL
INCREASE
SUPPORT
LEVEL
POWER
THROTTLE
- Choose the desired assist level by pushing the arrows on the handlebar control up/down.
Choose between level 1-5.
- To make the bike move with electric assistance you just have to pedal. The throttle works
as walk assist from 0 to 6 km/h. Please handle it gently and twist it only toward the back,
applying an intense force or twisting it toward the front could break it.
IMPORTANT: For safety reasons, on the 500W system the assist
level selection using the arrow buttons is disabled, so the bike
always requires throttle, before the motor is activated.
Regardless of the selected assist level shown in the display.
37