Tripp Lite NGI-M08POE8-L2 User Manual

105
IP multicast
address
Description
224.0.0.0
Base address (reserved)
224.0.0.1
The All Hosts multicast group that contains all systems on the same network
segment
224.0.0.2
The All Routers multicast group that contains all routers on the same network
segment
224.0.0.5
The Open Shortest Path First (OSPF) All SPF Routers address. Used to send
Hello packets to all OSPF routers on a network segment
224.0.0.6
The OSPF All D Routers address. Used to send OSPF routing information to
OSPF designated routers on a network segment
224.0.0.9
The RIP version 2 group address, used to send routing information using the
RIP protocol to all RIP v2-aware routers on a network segment
224.0.0.10
EIGRP group address. Used to send EIGRP routing information to all EIGRP
routers on a network segment
224.0.0.13
PIM Version 2 (Protocol Independent Multicast)
224.0.0.18
Virtual Router Redundancy Protocol
224.0.0.19 - 21
IS-IS over IP
224.0.0.22
IGMP Version 3 (Internet Group Management Protocol)
224.0.0.102
Hot Standby Router Protocol Version 2
224.0.0.251
Multicast DNS address
224.0.0.252
Link-local Multicast Name Resolution address
224.0.1.1
Network Time Protocol address
224.0.1.39
Cisco Auto-RP-Announce address
224.0.1.40
Cisco Auto-RP-Discovery address
224.0.1.41
H.323 Gatekeeper discovery address
6.2.5.1 CLI Configuration
Node
Command
Description
enable
show mac-address-table
multicast
This command displays the current
static/dynamic multicast address entries.
enable
show mac-address-table
multicast vlan <1-4094>
This command displays the current
static/dynamic multicast address entries with
a specific VLAN.
enable
configure terminal
This command changes the node to configure
node.
configure
mac-address-table multicast
MACADDR vlan <1-4094>
ports PORTLIST
This command configures a static multicast
entry.

Tripp Lite NGI-M08POE8-L2 Specifications

General

Brand	Tripp Lite
Model	NGI-M08POE8-L2
Category	Switch
Language	English