To Next PageTo Next Page
Need help?Do you have a question about the Tripp Lite SMART2200SLT and is the answer not in the manual?
General| Type | Line-Interactive |
|---|---|
| Capacity | 2200 VA |
| Input Voltage | 120 V |
| Nominal Input Voltage | 120 V |
| Output Voltage | 120 V |
| Output Frequency | 50/60 Hz |
| Waveform | Sine Wave |
| Typical Recharge Time | 8 hours |
| Form Factor | Tower |
| Output Connections | NEMA 5-15R |
| Surge Energy Rating | 480 Joules |
| Data Line Protection | Yes |
| Communication Ports | USB, Serial |
| Battery Type | Sealed Lead Acid (SLA) |
Provides guidance on proper placement and handling of the UPS to prevent damage and ensure safety.
Details critical instructions for connecting the UPS to AC power and avoiding electrical hazards.
Warns against using the UPS for life support applications and connecting surge suppressors to its output.
Outlines risks associated with batteries, proper handling, disposal, and replacement procedures.
Instructions for plugging the UPS into a grounded AC outlet on a dedicated circuit.
Guidance on connecting electronic equipment to the UPS output, avoiding overload.
Steps to power on the UPS by pressing and holding the ON/OFF/STANDBY button.
Instructions for connecting the UPS to a computer for monitoring and control via USB or RS-232.
Details on connecting the EPO port to an emergency power off circuit for shutdown control.
Details the ON/OFF/STANDBY and MUTE/TEST buttons for UPS operation and self-testing.
Explains the status indicated by POWER, VOLTAGE_CORRECTION, OUTPUT LOAD LEVEL, BATTERY CHARGE, and BATTERY WARNING LEDs.
Describes AC Receptacles, Communications Ports, EPO Port, and Accessory Slot on the UPS rear panel.
Covers Power Sensitivity Adjustment and the function of the Input Breaker.
Instructions for storing the UPS, including battery care and periodic charging to maintain capacity.
Steps for diagnosing issues, contacting support, and returning the UPS for repair or warranty.
Guidance on accessing the battery compartment and removing the front panel and support bar.
Steps for removing old batteries, connecting new ones, and reassembling the UPS unit.
