To Next PageTo Next Page
Need help?Do you have a question about the Tripp Lite SMART1300LCDT and is the answer not in the manual?
General| Type | Line Interactive |
|---|---|
| Output Power Capacity | 1300 VA |
| Input Voltage | 120V |
| Output Voltage | 120V |
| Number of Outlets | 8 |
| Form Factor | Tower |
| LCD Display | Yes |
| Output Voltage Regulation (Line Mode) | ±5% |
| Nominal Input Voltage | 120V |
| Input Frequency | 50/60 Hz |
| Input Connection Type | NEMA 5-15P |
| Output Connections | NEMA 5-15R |
| Battery Type | Sealed Lead Acid (SLA) |
| Typical Recharge Time | 8 hours |
| Data Line Protection | Yes |
| Audible Alarm | Yes |
| Frequency | 50/60 Hz |
| Communication Ports | USB |
| Output Voltage Regulation (Battery Mode) | +/- 5% |
| Waveform Type | Sine Wave |
| Transfer Time | 4 ms |
Step 1: Connect the UPS to a properly grounded AC power outlet.
Step 2: Plug connected devices into the UPS outlets, distinguishing between surge-only and battery backup.
Information on connecting communication ports and surge protection jacks.
Instructions on how to turn the UPS on and off using the power button.
Explanation of the various icons and indicators on the UPS LCD screen for modes and conditions.
How to view different UPS and site power information screens in line and battery modes.
Instructions for silencing or temporarily muting UPS alarms.
How to initiate and interpret the UPS self-test for battery health.
Explanation of different critical fault codes and their solutions.
