7
TRISAN S8 General description
Battery
The battery feature allows the tester to perform insulation and some leakage current tests. RCD
tests require batteries to be installed.
The battery is essential to hold date and time information. Operating with a printer and or
data logging mode, it is important that the date is accurate. Always check the time and date
by pressing the F1 menu button. (F1 ↑)
The instrument uses six AA size NiMH, Alkaline or Lithium battery cells.
Whether using Alkaline or NiMH batteries one to two thousand tests are achievable.
A prompt will be displayed to indicate when batteries are getting low. This prompt will reappear
regularly until action is taken to replace batteries.
BATTERY INSTALLATION.
♦
When installing batteries, the instruments battery compartment can contain hazardous volt-
age inside! Before opening the battery compartment cover, disconnect all accessories con-
nected to the instrument and switch off the instrument.
♦
Ensure that the battery cells are inserted correctly otherwise the instrument will not operate
and the batteries could be discharged.
♦
If the instrument is not to be used for a long period of time, remove all batteries from the
battery compartment.
♦
Rechargeable NiMH batteries type 6 (size AA) can be used. We recommend only using re-
chargeable batteries with a capacity of 1900 to 2600mAh.
♦
Dispose of batteries responsibly
To Next Page
Loading...