TRIUMPH BOARD a.s. Page 23 of 27
9) Hotkey Setting
2 x 10 hotkey features are available in TB Comenius MULTI Touch v6 and RM Easiteach software for
the user to set up. For the hotkeys to function properly only one Hotkeys Driver should run at a time,
not both simultaneously. If both of the drivers (TB Comenius MULTI Touch Driver v6 and RM Hotkeys
Driver) are installed and running, then before starting one of the programs please exit the Hotkeys
Driver of the other program.
a) TB Comenius MULTI Touch v6
Steps are as following:
Make sure that TB Comenius MULTI Touch Driver v6 is running (TB Comenius MULTI Touch Driver v6
icon is displayed in the system tray). If not, run it by double clicking on TB Comenius MULTI Touch
Driver v6 icon on your Desktop.
If RM Hotkeys Driver is running (RM Hotkeys Driver icon is displayed in system tray), click the right
mouse button and select Exit to cancel it.
1) Click on Tools in main
TB Comenius MULTI Touch v6
Program menu and choose
Calibration Hotkeys.
2) Choose Hotkey Size – 20*20 mm for
small Hotkey Strip (icons size 20*20 mm)
or 50*50 mm for big Hotkey Strip
(icon size 50*50 mm).
3) Use stylus of MULTI to point to Hotkey strip icons according to where the black/red cross is.
To Next Page
Loading...