12 of 20
45. Fit the end of the cable into the left hand rocker
arm, with the wheel of the rocker arm facing
towards the rear of the motorcycle and locate
the rocker arm into the clevis section of the third
mount, as shown below.
1. Pannier cable
2. Rocker arm
3. Wheel, rocker arm
4. Pannier third mount
46. Fit a shouldered bolt from the kit, with the head
of the bolt towards the front of the motorcycle,
to retain the rocker arm to the clevis of the left
hand third mount. Fit an M8 nut from the kit to
secure the shouldered bolt. Tighten the nut to
20 Nm.
1. Clevis, pannier third mount
2. Rocker arm
3. Shouldered bolt
47. Feed the opposite end of the pannier cable
through the large hole on the right hand side of
the battery tray moulding.
48. Repeat steps 42 to 46 for the right hand side of
the motorcycle.
When locating the rocker arm into the clevis section
of the third mount, ensure that the cable is
correctly located into the slot on the rocker arm. If
the cable is not correctly located it can be bent and
permanently damaged during rocker arm fitment
which will cause incorrect cable function. Incorrect
cable function may cause the motorcycle to become
unstable leading to loss of control and an accident.
2
1
3
4
Rear of the
Motorcycle
To Next Page
Loading...
