1414
Perform the following operations:
• Alternator Cover - Installation
• Battery - Installation
• Seat - Installation
• Crankshaft Position Adaption (European Markets Only)
Alternator Regulator/Rectifier – Removal
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Perform the following operations:
• Seat - Removal
• Battery - Removal
• Coolant Expansion Tank - Removal
Note the position and orientation of the heat shield for installation.
Note the positions of the electrical connectors for installation.
1. Remove the fixing, disconnect the two electrical connectors and remove the
regulator/rectifier.
To Next Page
Loading...
