778
3. Remove and discard the O-ring on the fuel injector.
4. Fit a new O-ring using finger pressure only.
5. Lightly lubricate the O-ring on the injectors and fit the injector/fuel rail assembly to
the cylinder head, orientating each injector such that the electrical connection is
facing upwards.
6. Fit the spacers between the fuel rail and cylinder head, fit the fuel rail cover, fit and
tighten the fixings to 6 Nm.
7. Connect the electrical connectors to the six fuel injectors.
1. Injector connector (2 of 6 shown)
2. Fixings
3. Cover
4. Spacers
Perform the following operations:
• Plenum - Installation (All Markets Except US) or Plenum - Installation (US
Markets Only)
• Fuel Tank - Installation
• Battery - Installation
• Seat - Installation
To Next Page
Loading...
