884
7. Tighten the radiator upper fixings to 6 Nm (right hand side first).
8. Tighten the radiator lower fixings to 6 Nm.
9. Fit the horn to the radiator assembly and tighten its fixing to 9 Nm.
10. Connect the horn electrical connectors.
Perform the following operations:
• Coolant Expansion Tank - Installation
• Coolant Replacement - Filling
• Radiator Cowl - Installation
• Battery - Installation
• Seat - Installation
Water Pump
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
The water pump is an integral part of the clutch cover. If the water pump requires
replacing, a new clutch cover with a water pump must be fitted (see Clutch Cover -
Removal).
To Next Page
Loading...
