GENERAL INFORMATION
68
Side Panels
All Models except Scrambler 900
The right side panel can be removed to
gain access to the adjustment tool and
the rear brake fluid reservoir.
1
2
2
1. Side panel (right hand shown)
2. Grommets
To remove either side panel:
▼ Grasp the panel firmly and pull the
panel away from the motorcycle
until it is free from the three
retaining grommets (leaving the
grommets in place).
To reinstall either side panel:
▼ Position the three locating dowels to
the grommets, then press firmly to
secure the panel.
▼ Finally, grasp the panel and make
sure that it is fully retained.
Scrambler 900
Left Hand Side Panel
The left hand side panel can be removed
to gain access to the adjustment tool.
2
1
2
1. Side panel (left hand shown)
2. Grommets
To remove the left hand side panel:
▼ Grasp the panel firmly and pull the
panel away from the motorcycle
until it is free from the three
retaining grommets (leaving the
grommets in place).
To reinstall the left hand side panel:
▼ Position the three locating dowels to
the grommets, then press firmly to
secure the panel.
▼ Finally, grasp the panel and make
sure that it is fully retained.
To Next Page
Loading...
