25
General Information
Turn Signal Indicators
When the turn signal switch is
turned to left or right, the
corresponding turn signal warning
light will flash on and off at the same speed
as the turn indicators.
High Beam
When the ignition is switched on
and the headlight dimmer switch is
set to 'high beam', the high beam
warning light will illuminate.
Neutral
The neutral warning light indicates
when the transmission is in neutral
(no gear selected). The warning
light will illuminate when the transmission is
in neutral with the ignition switch in the ON
position.
Low Fuel
The low fuel indicator will
illuminate when there are
approximately 1.2 US gal
(4.5 liters) of fuel remaining in the tank.
Alarm
The alarm light will illuminate
when the conditions described in
the accessory alarm instructions
are met.
ABS (Anti-lock Brake
System) Indicator Light
The ABS indicator light illuminates
to show that the ABS function is
not available. Illumination is normal after
engine start-up, and until the motorcycle first
reaches a speed exceeding 6 mph (10km/h).
Unless there is a fault, it should not illuminate
again until the engine is restarted.
If the indicator light becomes illuminated at
any other time while riding it indicates that
the ABS has a malfunction that requires
investigation.
If the ABS is not functioning, the brake
system will continue to function as a
non-ABS braking system. Do not continue
to ride for longer than is necessary with the
indicator light illuminated. Contact an
authorized Triumph dealer as soon as
possible to have the fault checked and
rectified. In this situation braking too hard
will cause the wheels to lock resulting in
loss of control and an accident.
To Next Page
Loading...
