Page 2
Congratulations on your purchase of the TROLLMasterProAngler. This
addition to the TROLLMaster lineup will allow you to control both your
trolling speed and direction from anywhere in the boat. In addition to
manual throttle and steering control, the ProAngler includes a Strike
Mode function which automatically adjusts engine speed based on one
of four selectable speed proles.
CONNECTIONS
Power/Battery Connection 6’ (1.8m) Red, 6’ (1.8m) Black
Connect the red 16AWG to positive 12V battery terminal. Connect the
black 16AWG to negative 12V battery terminal.
ACC+ Switched Power 15’ (4.6m) Red
Connect red 18AWG wire to switched accessory power at helm station.
2 Way Molded Connector 6’ (1.8m)
This connection is used to attach a Panther Electro Steer unit. Push the
molded connector to the corresponding connector on the Electro Steer
unit until it is snug and both ends of the connector meet.
Servo Connection 8’ (2.4m)
This wire will connect to the included Servo that mounts under the
cowling of the motor. For more details on how to install this servo refer
to the Hardware Kit you purchased that corresponds to your specic
To Next Page
Loading...