Page 3
make of motor. Route and secure servo cable as far away as practical
from the spark plug wires.
Pairing button
Pushing this button will pair your remote to your receiver. Push this
button once and the Activity light will be solid. Then press any button
on the remote. Once the light goes o, your remote is paired.
Activity Indicator
This blinks any time there is activity between your receiver and remote.
It will also be solid when you are in the process of pairing your remote.
Receiver Antenna
This wire is used for the receiver to be able to communicate to the remote. It
can lay loose and does not need any install attention.
MOUNTING HOLES
The holes are used to mount your receiver to ensure it is secure and will
not be tossed around while the boat is in motion.
QUICK START
1. Install your servo and throttle rod following the directions that come
with the hardware kit.
2. Find a suitable location to install your receiver that will be out of
direct contact with constant water exposure and can be mounted
securely but allows all cables to reach their destination.
3. Run your power cable from your receiver to your battery
4. Run your Acc+ Switched Power cable to helm station
5. Run your servo cable from your receiver out to your servo that was
installed on the kicker motor in Step 1.
6. (Optional) Connect your Panther Electro Steer motor to the 2 Way
molded connector on the receiver.
7. Pair your remote (See ‘Pairing button’ above)
8. Verify proper operation of the servo (and steering if connected).
9. Go shing!
For information on motor specic installation of the servo, please refer
to the installation instructions found at the TROLLMaster website:
http://trollmasters.com/wireless/trollmaster-proangler/
installation-guides
To Next Page
Loading...