02
FACTS
COMPONENTS
Here are some important things to consider when using the Aqua-X lrrigation Controller.
Each set of Aqua-X lrrigation Controller can connect up to 30 outputs (24Vor 110V) and monitor the pH
value, EC value and water temperature of nutrient.
The maximum number of connections to the Aqua-X is 5 pieces of 24V Control Board, 110V Control Board
or the Program Device Station (DSP-1 from Hydro-X system) when connected to the 110V control port in
any combination. A DSP-1 can be connected to the 24V Control Board as a “Master Pump" In this case, the
DSP would not be counted as one of the 5 devices. 24V Control Board (6outputs each). 110V Control Board
(6 outputs each) and Program Device Station (1 output each) can be used together but each Aqua-X can
only control up to 30 outputs.
The Water Detector port looks identical to the Control Board port. Make sure not to mix them up. The
Water Detector port is positioned between the Sensor Board port Micro SD slot.
pH Sensor and EC/Temp Sensor should be connected to Sensor Board (AMP-2) and then connect the
Sensor Board to the Aqua-X with a mini-DlN cable.
The maximum distance between the NFS-1 and the devices to be controlled is 1000 ft/ 300 meters.
Follow all local and national electrical codes for installation requirements.
●
●
●
●
●
●
1. Aqua-XController (NFS-1) 2. Water Detector (VD-1) 3. Water Touch Spot
4. Back Plate (Bracket) 5. 12 VDC Power Supply
To Next Page
Loading...
