USER MANUAL TST40E, V15.01 page | 4
Technical changes, misprints and errors are reserved.
1.3. Danger notices
- Do not install the lift on asphalt surface.
- Read and understand all safety warnings before operating the lift.
- The lift must not be used outside!
- Keep hands and feet away from any moving parts. Keep feet clear of the
lift during the lowering process!
- Do not wear unfit clothes such as large clothes with flounces, ties, etc.
which could be caught by moving parts of the lift.
- Always keep the lift and the lifting area clean and free of tools, parts,
debris etc.
- Do not exceed the max. lifting capacity of the lift!
- Always insure the safety latches are engaged before any attempt to work
near or under the vehicle
- Only use the vehicle manufacturer´s recommended lifting points!
- Check at any time the parts of the lift to ensure the agility of moving parts
and the performance of synchronization. Ensure regular maintenance and
if anything abnormal occurs, stop using the lift immediately and contact
your dealer/technician for help.
- Lower the lift to its lowest position and do remember to cut off the power
source when the service is finished.
- Do not modify any parts of the lift without the manufacturer´s approval!
- If the lift is not in use for a long time, lower it to its lowest position, cut off
the power source, empty the oil tank and lubricate all the moving parts
with hydraulic oil!
- The standard lift version may not be installed and commissioned in the
vicinity of explosives or flammable liquids.
- The standard lift version may not be installed and commissioned outdoors
or in moist rooms (e.g. car wash).
1.4. Training
Only these qualified people, who have been properly trained, can operate the
lift.
To Next Page
Loading...