Why do my Tronair Jacks fail to lift the rated load?
If your Tronair Jacks fail to lift the rated load, several factors could be at play. Ensure the release valve is fully tightened and that the fluid level is correct. The pressure relief valve may need adjustment or replacement. Check for leakage at the inlet or outlet check ball, inspecting the valve body for wear. Lastly, make sure the vent screw is open.
What to do if ram(s) raise and fall with each manual pump stroke on Tronair 02-7854C0110?
If the rams on your Tronair Jacks raise and fall with each manual pump stroke, the issue could stem from a few causes. First, ensure the release valve is fully tightened. If that's not the problem, the inlet check valve or the pressure check valve might not be seated correctly or could be sticking. Try pumping rapidly to dislodge any obstructions, or consider replacing the valve body.
Why Tronair Jacks ram(s) will not support load after manual or pneumatic pump up?
If the rams on your Tronair Jacks will not support the load after manual or pneumatic pump up, it could be due to leaking ram o-ring seals. Check for external leakage and if present, replace the defective seal and back up ring. Alternatively, it could be caused by a leaking pressure check valve or a leaking pressure relief valve. For the pressure check valve, inspect the valve body for wear or replace the valve body and check balls. For the pressure relief valve, remove the release valve and inspect the ball and ball seat in the pump block, replacing any defective parts.
How to fix Tronair 02-7854C0110 Jacks that fails to lower?
If your Tronair Jacks fail to lower, there are a few potential reasons. First, make sure the ram locknut is loosened by raising the jack ¼ inch and then releasing the locknut. Also, ensure the vent screw is open. Finally, check the O-ring for pinching or rolling; if damaged, replace the o-ring and back-up ring, and clean up any debris from the cylinder wall.
How to stop external fluid leakage at ram(s) on Tronair Jacks?
If you notice external fluid leakage at the rams of your Tronair Jacks, it may be due to a damaged o-ring, backup ring, or inner cylinder wall. Remove the ram(s) as a unit from the cylinder and inspect the parts. Replace the o-ring and any other defective parts.
What causes fluid leakage at pump piston or pump body in Tronair Jacks?
If you observe fluid leakage at the pump piston or pump body of your Tronair Jacks, it could be due to a damaged backup ring, o-ring, piston, or pump body. Remove the piston and pump body to inspect for damage. Replace any defective parts, and be sure to replace the removed o-ring and backup ring.
Procedures for raising nose and main aircraft gears, including placement and extension adjustments.
Detailed steps for disassembling and re-assembling the hydraulic jack components.
Procedure for testing jack capacity and function, ensuring safety precautions are followed.
Read and follow all safety precautions to avoid personal injury or property damage during system operation.
Instructions for connecting pumps, installing pressure gauges, and connecting hoses to cylinders or tools.
Steps to remove air from the hydraulic system for single and double-acting cylinders to ensure smooth operation.
A guide to diagnose and resolve common problems encountered with hydraulic pumps and cylinders.
Material classification and labeling according to regulatory guidelines, including hazard and precautionary statements.
Information on appropriate extinguishing media, fire-fighting instructions, and potential fire hazards.
Details on exposure limits, engineering controls, and recommended personal protective equipment.
Classification and regulations for transporting the material via land, sea, and air.
Recommended preventative maintenance procedures for axle jacks, including 90-day inspections and annual load tests.
To Next Page
General
