tronical TronicalTune - Interference Level

BAT
e B G D A E
MENU
BAT
e B G
MENU
BAT
MENU
SETS THE INTERFERENCE LEVEL FOR ALL TUNING MODES.
DEFAULT IS 3LEDS
SELECT BETWEEN A HIGH AND LOW INTERFERENCE LEVEL
TO PREVENT THAT THE HARMONIC OF A LOW STRING IS
RECOGNIZED AS A HARMONIC OF A HIGH STRING.
E
E
A
A
D
DGBe
e
LEFT / RIGHT
ENTER
INTERFERENCE LEVEL
BACK
high
low
EXAMPLE: HIGHEST INTERFERENCE LEVEL.
35WWW.TRONICAL-COMPONENTS.COM
INTERFERENCE LEVEL
e
CONFIGURATION MENU
PUSH “ON“ BUTTON. THE SYSTEM COMES UP WITH THE LAST COMPLETED
TUNING IN MULTISTRING MODE. PUSH “BACK“ BUTTON TO ENTER TUNING
SELECTION MODE. MENU LED IS OFF. TO ENTER CONFIGURATION MENU
PRESS AND HOLD THE “DOWN“ BUTTON UNTIL MENU AND “E“ LED LIGHTS
UP LIGHT BLUE. TO ACCESS INTERFERENCE LEVEL SELECT “e“LED AND
PRESS ”ENTER”.
ENTER
DOWN
LEFT / RIGHT
ON/BACK
i
i
A GUITAR STRING IS PRODUCING NOT ONLY THE FUNDAMENTAL
FREQUENCY BUT ALSO SEVERAL OVERTONES E.G. THE E STRING IS
PRODUCING 82.41 HERTZ AS FUNDAMENTAL AND OVERTONES AT
164.82, 247.23 AND SO FORTH.
THAT MEANS THAT THE ESTRING IS INTERFERING WITH THE BSTRING
BECAUSE THE SECOND OVERTONE OF THE ESTRING AND THE FUNDA
MENTAL OF THE BSTRING INTERFERE AROUND 247 HERTZ.
WHEN YOU RECOGNIZE THAT THE ROBOHEAD OF THE B STRING IS
TURNING WITHOUT PLUCKING THE BSTRING REDUCE THE INTERFE
RENCE LEVEL. IF YOUR GUITAR IS NOT PRODUCING PRONOUNCED
OVERTONES YOU CAN INCREASE THE INTERFERENCE LEVEL TO IM
PROVE PERFORMANCE.