EasyManuals Logo

Trotec BE20 User Manual

Trotec BE20
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10 EN
voltage detector BE20
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not respond:
The battery voltage is too low. Exchange the batteries
immediately.
The voltage detection results in the LED display being
inexplicable:
The battery voltage is too low. Exchange the batteries
immediately.
Check all cable connections for potential defects. In case
of defective connections/cables, you must not continue
using the device.
The device still does not operate correctly after these
checks?
Please contact the Trotec customer service.
Maintenance and repair
Battery change
A battery change is required if the continuity test indication(12)
is no longer illuminated and no acoustic signal is emitted when
holding both test probes together.
Cleaning
Clean the device with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Do not use any
sprays, solvents, alcohol-based cleaning agents or abrasive
cleaners, but only clean water to moisten the cloth.
Repair
Do not modify the device or install any spare parts. For repairs
or device testing, contact the manufacturer.
Disposal
The icon with the crossed-out waste bin on waste
electrical or electronic equipment stipulates that this equipment
must not be disposed of with the household waste at the end of
its life. You will find collection points for free return of waste
electrical and electronic equipment in your vicinity. The
addresses can be obtained from your municipality or local
administration. For further return options provided by us please
refer to our website www.trotec24.com.
The separate collection of waste electrical and electronic
equipment aims to enable the re-use, recycling and other forms
of recovery of waste equipment as well as to prevent negative
effects for the environment and human health caused by the
disposal of hazardous substances potentially contained in the
equipment.
In the European Union, batteries and accumulators must not be
treated as domestic waste, but must be disposed of
professionally in accordance with Directive 2006/66/EC of the
European Parliament and of the Council of 6September 2006
on batteries and accumulators. Please dispose of batteries and
accumulators according to the relevant legal requirements.

Other manuals for Trotec BE20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Trotec BE20 and is the answer not in the manual?

Trotec BE20 Specifications

General IconGeneral
BrandTrotec
ModelBE20
CategoryCircuit Tester
LanguageEnglish