Trotec PAC 2000 SH User Manual

EN 4
Operating manual – local air conditioner PAC 2000 SH
Device depiction
1
2
3
4
2
3
9
8
7
6
5
10
11
No. Designation
1 Control panel
2 Handle
3 Wheels
4 Air inlet with air filter
5 Hose connection with rubber stopper
6 Power cable holder
7 Exhaust air hose connection
8 Condensate outlet with rubber stopper
9 Remote control
10 Remote control receiver
11 Air outlet with ventilation flaps
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with wheels.
Before transporting the device, observe the following:
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Drain the remaining condensate from the device.
• Do not use the power cable to drag the device.
• Only wheel the device on a level and smooth surface.
After transporting the device, observe the following:
• Set up the device in an upright position after transport.
• Leave the device to rest for 12to24hours, so the
refrigerant can accumulate within the compressor. Wait
12to24hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.

Trotec PAC 2000 SH Specifications

General

Brand	Trotec
Model	PAC 2000 SH
Category	Air Conditioner
Language	English