Trotec PAE 49 - Timer Functions

EN 13
air cooler PAE 49 / PAE 50
3. Press the Humidity button(28) again to switch air cooling
off.
ð The Humidity LED(27) goes out.
ð The device continues to run in the previously selected
operating mode.
Note
When Air cooling mode is activated, the air and
evaporation filter must not be removed, otherwise the
water from the filter will drip down into the device.
Air freshening
In Air freshening mode, the fan speed increases and decreases
alternately to generate a pleasant, natural air stream.
Please proceed as follows to activate air freshening:
1. Press the Mode button(29) until the Air freshening
LED(18) is illuminated. The fan stages are automatically
adjusted.
Ventilation
In ventilation mode, you can select all 4fan speeds manually.
Please proceed as follows to activate Ventilation:
1. Press the Mode button(29) until the Ventilation LED(26) is
illuminated.
2. To adjust the fan stage, press the Speed button(33) until
the LED for the desired fan stage(20) is illuminated.
Night mode
In night mode, it is possible to additionally switch on air cooling.
Air freshening cannot be activated.
The timer is automatically set to 8h.
In night mode, the device operates using a preset programme
with different fan speeds to generate an air stream that is
adapted to human sleeping habits.
1. Press the Mode button(29) until the Night mode LED(19)
is illuminated.
Setting the timer
The timer has two modes of operation:
• automatic switch-on upon expiry of a preset number of
hours.
• automatic switch-off upon expiry of a preset number of
hours.
The function can be set in all operating modes and also during
stand-by.
The number of hours can be set to 1h, 2h, 4h or 8h.
Automatic switch-on
ü The device is switched off.
1. Press the Timer button(30) until the desired number of
hours is displayed by the Hours LEDs(25).
ð The timer setting equals the desired number of hours.
ð The device automatically starts in the previously selected
operating modes after the set number of hours has elapsed.
Notes regarding automatic switch-on:
• Manually switching the device on disables the automatic
switch-on function.
• If the power supply is interrupted, the timer and memory
function will be deactivated.
Automatic switch-off
ü The device is switched on.
1. Press the Timer button(30) until the desired number of
hours is displayed by the Hours LEDs(25).
ð The timer setting equals the desired number of hours.
ð The device switches off automatically after the set number
of hours has elapsed.
Notes regarding automatic switch-off:
• Pressing the On/ Off button(34) deactivates the automatic
switch-off function.