Trotec PAE 49 - Errors and Faults Troubleshooting; Device Not Starting; Reduced or No Capacity; No Air Cooling or Pump Operation

16 EN
air cooler PAE 49 / PAE 50
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation Article number
Evaporation filter 7.710.000.862
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
• Check the power connection.
• Check the power cable and mains plug for damage.
• Check the on-site fusing.
• Wait for 10minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device works with reduced or no capacity:
• Check the position of the horizontal ventilation flaps. They
should be opened to the maximum.
• Check the air filter for dirt. If necessary, clean or replace
the air filter.
• Check the minimum distance to walls or other objects.
Position the device a little more in the room's centre if
required.
The device is running, but there is no air cooling or pump
operation:
• Check whether air cooling mode is activated. The Humidity
LED(27) should be illuminated.
• Check the filling level of the water tank (see chapter Filling
the water tank). The Humidity LED(27) should not flash.
• Check whether there are any objects blocking the pump
inlet. Make sure that the pump inlet is not blocked.
• In case the pump does not operate despite a correctly filled
water tank and activated air cooling mode, the pump might
be defective. Please contact the customer service.
Water is leaking:
• Check the device for leaks.
• Check the water tank for tight fit.
The swing function is not working:
• The swing function motor might be defective. Please
contact the customer service.
The device is loud or vibrates:
• Check whether the device is set up in a stable and upright
position.
The device does not respond to the infrared remote control:
• Check whether the distance between remote control and
device is too large and reduce it if necessary.
• Make sure there are no obstacles, such as furniture or
walls, between the device and the remote control. Ensure
visual contact between device and remote control.
• Check the charging status of the batteries and change
them if required.
• If the batteries have just been changed, check them for
correct polarity.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.