Trotec PAE 49 - Start-up and Setup; Initial Setup and Checks

8 EN
air cooler PAE 49 / PAE 50
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Only put up the device in an upright, stable position on firm
ground.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• Make sure that no curtains or other objects interfere with
the air flow.
Prior to initial start-up, insert batteries in the remote control.
Mounting the feet
If you want to position and operate the device on a slope, first
mount the feet.
1. Place the device on its side and position the feet.
1.
2.
2. Fasten each foot on the device with one screw.