Trotec TVE 25 S User Manual

EN 5
pedestal fan TVE 25 S
6
7
No. Designation
1 Protective grid
2 Control panel
3 Foot
4 Motor
5 Pillar
6 Oscillation pin
7 Remote control
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before transporting the device, observe the following:
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Do not use the power cable to drag the device.
After transporting the device, proceed as follows:
• Set up the device in an upright position after transport.
Storage
Before storing the device, proceed as follows:
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
• Store the device in a dry location and protected from frost
and heat.
• If required, use a cover to protect the device from invasive
dust.
• Place no further devices or objects on top of the device to
prevent it from being damaged.
• Remove the batteries from the remote control.
Assembly and start-up
Scope of delivery
• 1x Device TVE 25 S
• 1 x Remote control (without batteries)
• 1x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.

Trotec TVE 25 S Specifications

General

Brand	Trotec
Model	TVE 25 S
Category	Fan
Language	English