Trotec TVE 25 S User Manual

8 EN
pedestal fan TVE 25 S
Adjusting the height
Turn the height adjustment screw to be able to set the
appropriate device height.
110 cm –
130 cm
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
Warning
Risk of injury due to incorrect start-up!
There is a risk of injury if the protective grid is not
installed correctly around the impeller. The protective
grid must be installed correctly before the device is
switched on.
Warning
Risk of injury if protective grid is removed!
There is a risk of injury if the protective grid is removed
during operation. Do not remove the protective grid
while the device is in operation!
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Only put up the device in an upright, stable position on firm
ground.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• Make sure that no curtains or other objects interfere with
the air flow.
Inserting batteries into the remote control
Warning of electrical voltage
Do not touch the battery compartment with wet or
damp hands.
Note
Do not use rechargeable batteries! Observe the
Technical data for start-up.
Remove the battery cover(8) above the remote control's battery
compartment and insert two AAAbatteries(1.5V).
8
Connecting the power cable
• Insert the mains plug into a properly fused mains socket.
• The symbols on the control panel display light up briefly.
The device is now in standby mode.

Trotec TVE 25 S Specifications

General

Brand	Trotec
Model	TVE 25 S
Category	Fan
Language	English