Troy-Bilt 13A-344-563 User Manual (English)

Questions and Answers:

A
Austin RossJul 30, 2025
Why is my Troy-Bilt 13A-344-563 Lawn Mower leaving uncut strips?
- K
  Kimberly HayesJul 31, 2025
  If your Troy-Bilt Lawn Mower isn't discharging grass or leaves uncut strips, here's what might be happening: * The engine speed might be too low - set the throttle to full. * Your ground speed might be too high - use a lower ground speed. Remember that a slower ground speed improves the quality of cut. * The cutting height may be set too low - raise the deck. * The blades may be short or dull - sharpen or replace the blades.
T
Tyler NunezAug 7, 2025
What to do if Troy-Bilt 13A-344-563 Lawn Mower belt is broken?
- A
  Amy CastilloAug 7, 2025
  If the belt on your Troy-Bilt Lawn Mower is broken: 1. Inspect the rider for any foreign objects stuck between the deck and frame, or in the belt path. Remove any obstructions and check for damage. Replace the belt if needed. 2. Ensure you are using the correct belt. Replace with the proper belt, referencing the Parts list in this manual for the correct part number. 3. Engage the belt slowly by depressing the blade engagement pedal slowly. 4. If the belt is defective or damaged, replace it with the proper belt, following the instructions in the “Servicing Your Riding Mower” chapter.
D
Daniel JacobsAug 15, 2025
What to do if Troy-Bilt 13A-344-563 Lawn Mower belt keeps coming off?
- V
  vhaasAug 15, 2025
  If the belt on your Troy-Bilt Lawn Mower keeps coming off, it could be due to: 1. The belt being too loose or stretched. Readjust the belt or replace it if needed, following the belt replacement instructions in the “Servicing Your Riding Mower” chapter. 2. A broken or weak idler spring. Replace the spring, ordering the correct part number from the Parts List in this manual.
R
Roy ReeseAug 21, 2025
How to stop excessive vibration in Troy-Bilt 13A-344-563?
- E
  elizabeth63Aug 21, 2025
  To address excessive vibration in your Troy-Bilt Lawn Mower: 1. Immediately stop the engine. Check all pulleys, blade adapters, keys, and bolts for tightness and spindle damage. Tighten or replace any damaged parts. 2. If the blade is bent, stop the engine immediately and replace the damaged blade. Only use original equipment blades.