Operation
NOWTO USEYOUR
PRESSURE WASHER
If you have any proNems operating your pressure washer,
pHeasecall the pressure washer heHpHineat 1-888-611-6788.
To Start Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
aHso appHies if you have Het the pressure washer sit idHe for
at Heast a day.
H. PHace pressure washer near an outside water source
capaHe of suppHyin8 water at a flow rate greater than
3.7 gallons per minute and no Hess than 20 PSI at
pressure washer end of garden hose.
2. Check that hish pressure hose is connected to spray
sun and to pump. See "Preparin 8 Pressure _A/asher for
Use" for illustrations.
3. Hake sure unit is in a level position.
4. Connect 8arden hose to water inlet on pressure
washer pump. Turn ON water.
6.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
Squeeze triter on sun until you have a steady stream
of water.This purges pump of air and impurities.
Attach nozzle extension to spray sun (Fisure IO).
Tighten by hand.
7. Place colored quick connect spray tips in slots on
holder that's attached to nozzle extension (Figure II).
8. Choose spray tip you want to use and insert it into
nozzle extension. See "How to Use SprayTips" on
page I O.
9. Ensase safety latch to spray sun trigger (Fisure 12).
_ Safety Latch
IO. Move variable pressure control lever to "High"
position, shown on ensine as a rabbit (Fisure 13).
0
To Next Page
