Section 4: Operation
WARNING
When starting engine, pull cord slow, iy until resistance is felt
and then pull rapidly to avoid kickback.
If engine s_arts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
NOTE: Always keep the throttHe Hever in the "Fast"
_osition when operating the pressure washer.
WANNING
DO NOT touch hot surfaces.
Allow equipment to cool before touching.
The pressure washer must be at least 5 feet from structures
having combustible w,alIs and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer" for adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar laws. Federal laws applyon federal
lands. [f you equip the muffler with a spark arrester, it must be
maintained in effective working order.
1
Now to StopYour Pressure Washer
[, Let engine idle for two minutes.
2, Turn engine off according to instructions given in
engine owner's manual
3, Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid injury,
WANNING
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
Squeeze triger on spray gun to relieve trapped pressure,
every time you stop engine. Engage triD_er lock on spray gun.
NOTE: A small amount of water will squirt out when
pressure is released,
4. Engage trigger lock on spray gun when not in use,
Now to Use the Spray Tips
The quick-connect on the nozzle extension allows you to
switch between five different spray tips,The spray tips vary
the spray pattern as shown below (Figure 10).
CAUTION
NEVER exchange spray tips without locking the trigger lock
on the trigger.
Low Pressure
Use to apply
chemical
Black White
40°
Green
25°
Yellow
15°
High
Pressure
Red
0o
To Next Page
Loading...
Need help?
General
