SPECmFmCATmONS
Oudet Pressure ......................... 3700 psi
Row Rate .............. 4.0 gallons per minute (gpm)
Detergent Use detergent approved for pressure washers
Water Supply ................ Not to Exceed IO0°F
Automatic Cool ............. Will cyde when water
Down System reaches 125°° 155°F
Shipping Weight .......................... ISS Ibs,
GENERAL MAmNTENANCE
RECOMMENDATmONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.
NOT_:: Should you have questions about replacing
components on your TroyoBilt pressure washer, please call
1-888-611-6708 for assistance.
° Some adjustments will need to be made periodically to
properly maintain your pressure washer.
o All maintenance in this manual and the engine owner's
manual should be made at least once each season.
o If equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi.
Before lSach Use
I. Check engine oil level.
2. Check water inlet screen for damage.
3. Check inoline filter for damage.
4. Check high pressure hose for leaks.
5. Check detergent siphoning tube and filter for damage.
6. Check spray gun, nozzle extension, and spray tips for
leaks.
7, Rinse out garden hose to flush out debris,
PRESSURE WASHER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the water inlet. Clean it if the
screen is clo&!_ed or replace it if screen is damaged.
_h Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose. Replace it.
Replacement hose rating IvIUST exceed maximum pressure
raring of unit,
_ent Siphoning Tube
Examine the filter on the detergent tube and clean if
do_ed.The tube should fit tighdy on the barbed fitting.
Examine the tube for leal<s or tears. Replace the filter or
tube if either is damaged.
Check Gun and Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it springs back into place when you release it. Put the
safety latch in the on position and test the tri&!_er.You
should not be able to press the triter.
To Next Page
Loading...
Need help?
General
