ASSEMBLY
mMPORTANT: Read entireowner'smanuaH beforeyou
attempt to assembHeor operate your new pressure washen
Remove Pressure 4asher From
Remove high pressure hose_ handHe_and parts box
incHuded with pressure washer.
SHicetwo corners at end of carton from top to bottom
so paneH can be folded down fiat, then remove aHH
pacHdngmaterial
RoHHpressurewasher out of carton.
Carton Contents
[terns in the carton include:
Main unit
High pressure hose
Spray gun with qock connect fitthlg
Nozzle extension with qock connect fitting
HandHe
Engine oil
Safety goggles
Parts Bag OncHudes the foHHowing):
Owner's registration card
Bag containing 5 muHti-coHored quick connect
spray tips
Owner's manual
Engine manual
Emissions control warranty sheet
Handle Fastening Hardware Kit (which includes):
Carriage Bolts (2)
PHastic Knobs (2)
[f any of the above parts are missing or damaged, caHHthe
pressure washer he[p[ine at [-888-6 [ [ -6708.
PREPARING PRESSURE
WASHER FOR USE
If you have any probHems with the assembHy of your
pressure washer or if parts are missing or damage& caHHthe
pressure washer heHpHineat i -888-6 i i -6708.
To prepare your pressure washer for operation, you
wii[ need to perform these tasks:
H. Firthout and send in registration card.
2. Verify oiHdipstick has been installed into pump (Figure H).
3. Attach handle to main unit.
4. Add oiHto engine.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Connect nozzHeextension to spray gun.
9. SeHectand instaHHdesired quick connect spray tip.
0
To Next Page
Loading...
Need help?
General
