Troy-Bilt 21B-34M8711 User Manual

TROY-BILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
OperatOr’s Manual
Safe Operation Practices • Set-Up • Operation • Service • Replacement Parts • Warranty
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
Front Tine Tiller — Colt FT
NOTE: This Operator’s Manual covers several models. Features may vary by model. Not all features in this manual are applicable to all
models and the model depicted may differ from yours.
Form No. 769-11849
(August 26, 2016)

Troy-Bilt 21B-34M8711 Specifications

General

Engine Type	4-Cycle
Tilling Width	21 inches
Engine	Briggs & Stratton
Tine Location	Rear
Fuel Tank Capacity	1.5 quarts
Oil Capacity	20 oz
Tilling Depth	7 inches
Wheel Size	8 inches
Tine Rotation	Counter-rotating

Summary

To The Owner

Thank You and Introduction

Expresses gratitude for purchasing the tiller and provides an overview of the manual's purpose.

Product Information and Support

Instructions on recording product details and contacting customer support for assistance.

Important Safe Operation Practices

Operator Training and Preparation

Covers essential training requirements, pre-operation checks, and safe practices for operating the tiller.

Safe Gasoline Handling

Provides critical safety instructions for handling flammable gasoline to prevent injury or damage.

General Operation Safety

Outlines safety rules during machine operation, including warnings about moving parts and conditions.

Emissions, Spark Arrestor, and Symbols

Information on emissions, spark arrestor requirements, and explanations of safety symbols used in the manual.

Assembly & Set-Up

Contents, Tools, and Tine Installation

Details the contents of the carton, recommended tools, and step-by-step instructions for tine installation.

Wheel, Depth Stake, and Handle Assembly

Guides through the assembly of the wheel, depth stake, and handle components of the tiller.

Handle Adjustments and Operational Setup

Covers handle adjustments, cable guidance, clutch cable adjustment, and gas/oil fill-up procedures.

Controls & Operation

Control Identification and Engine Start

Identifies key controls like clutch lever, depth stake, and tines, plus engine starting procedures.

Depth Settings and Handle Pressure

Explains how to set tilling depth using wheels and depth stake, and influence of handle pressure.

Tilling Procedures and Other Uses

Details tilling procedures, cultivating techniques, and alternative uses like lawn preparation and soil mixing.

Service

Maintenance Procedures

Covers essential maintenance tasks including cleaning, lubrication of pivot points, and tine/wheel shaft care.

Belt Replacement and Troubleshooting

Instructions for replacing the drive belt and troubleshooting common issues with tines and wheels.

Replacement Parts

Tine and Hardware Components

Lists part numbers and descriptions for tines, cotter pins, and clevis pins used in the tiller.

Belts, Cables, and Wheels

Provides part numbers and descriptions for drive belts, clutch cables, and wheels.

MANUFACTURER'S LIMITED WARRANTY

Warranty Coverage and Exclusions

Details the warranty period, what is covered, and specific exclusions for the tiller and its parts.

Obtaining Service and Legal Rights

Instructions on how to obtain warranty service and information on state-specific legal rights.