Section 6 — Maintenance & adjuStMentS 21
1. Before adjusting the belt, shut off the engine, allow the
engine and muffler to cool down, disconnect the spark plug
wire and remove the ignition key on electric start models.
2. Remove the two lock nuts and remove the belt cover. See
Figure 6-8.
Figure 6-8
3. Reverse belt tension adjustments are done with the reverse
clutch cable adjuster located on the left side of the machine
near the engine. See Figure 6-9. Use two ⁄” open-end
wrenches to loosen the two adjuster jam nuts a few turns.
Reverse Clutch
Cable Adjuster
Adjuster Jam Nuts
Figure 6-9
4. Move the cable adjuster away from the pulleys to increase
the belt tension.
5. Tighten both jam nuts securely.
6. Reinstall the belt cover.
7. Move the tiller to an open area and test the reverse
operation. Repeat this procedure if the machine does not
respond when the reverse clutch is engaged.
Off-Season Storage
When the tiller won’t be used for extended periods, prepare it for
storage as follows:
1. Clean the tiller and engine.
2. Do routine tiller lubrication and check for loose parts and
hardware.
3. Protect the engine and perform the recommended engine
maintenance by following the engine storage instructions
found in the separate Engine Operator’s Manual.
NOTE: Be sure to protect the fuel lines, carburetor and fuel
tank from gum deposits by removing fuel or by treating
fuel with a fuel stabilizer. Follow the engine manufacturer’s
recommendations.
4. Fully Charge the battery. The battery loses some of its
charge each day.
NOTE: Never store the battery without a full charge.
Recharge the battery before returning to service. When
storing the tiller for extended periods, disconnect the
battery cables. Removing the battery from the machine is
recommended.
5. Store the tiller in a clean, dry area.
6. Never store the tiller with fuel in the fuel tank in an
enclosed area where gas fumes could reach an open flame
or spark, or where ignition sources are present (space
heaters, hot water heaters, furnaces, etc.).
To Next Page
Loading...
