Default** – set this mode to connect to weigh scale indicators and most
software systems.
HID (Human Interface Device) – set this mode if you want the scanned EID tag
to be automatically transmitted to a spreadsheet (e.g. Excel), or another device
that has not directly integrated with the stick reader.
Default** – Leave this set to Default unless you have been instructed to change
it by a Datamars representative.
Standard** – Press the Read button to scan a tag. Hold down the Read button to
continuously scan tags.
Continuous – Press the Read button to continuously scan tags. Scanning will only
stop when the Read button is pressed again.
Single – Press the Read button to scan a single tag. Even if you hold down the Read
button, another tag will not be scanned.
Tag Format -
Format and example shown:
A0000000964000000123456 (animal) or
R0000000964000000123456 (non-animal)
To Next Page
Loading...
Need help?
General