True Induction Double Burner User Manual

Troubleshoong Error Codes
If the display shows an error code, please refer to this sheet for a potenal soluon.
Error Code Cause and Potenal Soluon
“_ _ _” on display and beep sounds
 Cookware is not compable with the inducon cooktop.
 There is no cookware on the inducon cooktop.
Make sure the cookware is inducon compable as explained on the previous
page.
E1  Voltage is under 75V
E2  Voltage is over 145V
E3/E4  The unit may be damaged, contact seller for support.
E5
 The temperature sensor in the unit is defecve or there is a short circuit.
Contact seller for support.
E6
 The cooking temperature is over 450°F in the TEMP mode. Aer 3
minutes in standby, the unit will switch o and can it be restarted.
E7
 The venlaon area is blocked and heat cannot blow out of the unit
smoothly. This can cause the internal device to over-heat. Please keep a
minimum distance of 2 to 4 inches from the unit to the walls or other bar-
riers.
 To x the code, turn power OFF, remove plug from outlet, and allow the
unit to cool fully. Aer allowing venlaon space, plug the unit back into
the outlet and restart.
E9
 The temperature of sensor is lower than 122°F or 104°F aer the unit has
been operang for 6 minutes. This may be caused by a big pot of water
heang under a lower power level with a low indoor temperature.
 The sensor under the glass is damaged and needs to be replaced. Contact
seller for support.
EE
 The built-in safety feature funcon indicates that the unit has been on for
150 minutes. The inducon cooker will display “EE”, make an alert sound
and then go into standby mode. Simply press the ON/OFF buon to re-
state and resume cooking
8

True Induction Double Burner Specifications

General

Brand	True Induction
Model	Double Burner
Category	Cooktop
Language	English